1
Step 3 - Bolt Frame Together & Add Finishing Touches
Posted by YouMadeMeDoIt,
04 July 2012
·
143 views
frame naze32 fpv
Just finished up this frame and did a maiden flight. All went well! The video will be added to the post shortly!
Here are the rest of the build details:
Motors: Turnigy Park480 850 KV
Receiver: Orange 7CH with Falisafe and Satellite
ESC's: Dynam Detrum 30a flashed with SimonK software
Power distribution: Quadcopter Power Distribution Board from DIY Drones
Control Board: Naze32 (until a CC3D can take it's place!)
Landing Gear: Extra Large, colorful pool noodles. Yellow is the front.
Props: APC 11x4.7 Slow Flyers
The top level will hold a camera up front mounted inverted which will have no props in view, as well as a camera in the rear facing either down or backwards.
First measured flight time: 12 mins 42 secs.
Here are the rest of the build details:
Motors: Turnigy Park480 850 KV
Receiver: Orange 7CH with Falisafe and Satellite
ESC's: Dynam Detrum 30a flashed with SimonK software
Power distribution: Quadcopter Power Distribution Board from DIY Drones
Control Board: Naze32 (until a CC3D can take it's place!)
Landing Gear: Extra Large, colorful pool noodles. Yellow is the front.
Props: APC 11x4.7 Slow Flyers
The top level will hold a camera up front mounted inverted which will have no props in view, as well as a camera in the rear facing either down or backwards.
First measured flight time: 12 mins 42 secs.
