70 replies to this topic

[macranger]

But in your config i have to solder the orange and purple wires to the servo.

"Orange
PWM Signal 5 or PWM Output channel 9 7
5
Purple
PWM Signal 6 or PWM Output channel 10 8
6"

Is that right?

[AlPackin]

yes, orange is output #9 and purple is output #10 and they would go to the servos in the configuration that I made.
also yellow is output #7 and it would go a motor ESC
there would be no connection to the header at output #6 or to green output #8

You would probably get many more responses if the title of this thread was about camera stabilization rather than S Bus.  Not too many people use S Bus and would likely not read this thread

[macranger]

But why yellow? I thought the motors are connect to the s-bus reciever?

[AlPackin]

macranger, on 20 February 2012 - 02:53 PM, said:

But why yellow? I thought the motors are connect to the s-bus reciever?

now you have me totally confused ....

As far as I know the S Bus receiver just connects your radio transmitter, sticks and switches, to a serial port on CC.  The motors and servos are controlled by CCs PWM outputs.

[dezent]

Your receiver can use both SBUS and PWM,
if you use this cable you will use PWM. **NO SBUS**







If you use this cable you will use sbus. and NOT PWM



Now to explain thing, you will not use SBUS between CopterControl and your servos, that will be PWM.
The only place SBUS will be used is between your receiver and CopterControl.

[macranger]

Hi Dezent.
Look at this:

http://forums.openpi...-stabilization/

[dezent]

macranger, on 24 February 2012 - 07:07 AM, said:

Hi Dezent.
Look at this:

http://forums.openpi...-stabilization/

Yes i have looked at it, there is no SBUS to the servo´s in that picture.

[macranger]

Yes i use sbus in the mainport for the 6 motors.

And i use the recieverport with this cable for the 2 servos:
 ReceiverCable.jpg   83.88K   0 downloads

[dezent]

macranger, on 24 February 2012 - 10:03 AM, said:

Yes i use sbus in the mainport for the 6 motors.

And i use the recieverport with this cable for the 2 servos:
ReceiverCable.jpg

You use SBUS for the motors? i am pretty sure you use pwm but you might know something
i don't know.
But it would be interesting to know what you mean when you say you are using SBUS for
motors.

[macranger]

Sorry my english is not very well so it's dufficult to explain.
The Sbus Cable got to the mainport and the esc from to motors to the board.

Attached Files

•  sbus.jpg   222.09K   11 downloads

[dezent]

aah, that is not SBUS